• Hull:
The boat is dry, has no damage, the hull is made of epoxy resin and has a side thickness of the underwater part of more than 5 centimeters. In October 2023, all layers of old antifouling were removed, it was primed with epoxy primer and 4 layers of fulling were applied. Also:
1. Fully painted with gelcoat in 10/2023
2. antifouling hempel systems primer+ anti filling 10/2023
3. Teak repair 5/2024
4. Repair of shrouds 7/2024
5. Inspection and adjustment of standing rigging 5/2024
6. Repair of deadwood pipe 10/2023
7. Polishing repair of all stainless steel structures 7/2024
8. Replacement of all glass on hatches 4/2024
9. Replacement of all kingstons and cranes 10/2024
•Anchor equipment:
Anchor winch fully serviced 5/2024
100 meters of new chain 10/2023
•Bow Thruster 5.5 kw serviced 5/2024
Works flawlessly, the controls are located at both posts.
•Sail rigging:
The boat has a staysail schooner sail rigging, it is easy to control, thanks to small sails and automatic strakes it allows you to change the tack without leaving the wheelhouse in bad weather. A virtually clean deck and passages from the running rigging make moving around the boat comfortable. The condition of all the sails is excellent, replacement/repair/cleaning is not required. Completeness:
1. Genoa 110% furling service, sail repair and cleaning 6/2024
2. Staysail #1 service and cleaning 6/2024
3. Trysail service and cleaning 6/2024
4. Staysail #2 service and cleaning 6/2024
5. Mainsail repair cleaning and maintenance of the reefing system/replacement of running rigging 6/2024
6. 7/2024 sewn and installed lazy bag, all covers for sails. There is also a 2nd set of blue covers repaired 6/2024
7. There are 2 sun awnings in good condition.
•deck equipment
1. Mooring lines with damper springs 2 pcs 8 by meters 7/2024
2. Mooring ends with a lag of 22 mm 2 pcs 12 m by 5/2024
3. Round fenders 3 pcs
4. Fenders A4 9 pcs new covers 5/2024
The interior space is organized around the wheelhouse - the deck saloon. This is one of the main highlights of the nauticat 44 with a 360 ° view and a huge sliding hatch in the ceiling.
The boat has 2 cabins, 2 toilets, a shower, a gas water heater to have hot water absolutely always.
Works:
1. Removing varnish/treating all surfaces in the wheelhouse with teak oil 2/2024
2. Sewing an absolutely new salon with a complete replacement of foam rubber and fittings 3/2024
3. Repair/replacement of faulty furniture fittings 2/2024
4. Dismantling, cleaning and repairing the water tank with dismantling the salon in the galley 3/2024
5. Replacing the fresh water supply pump 3/2024
6. Fresh water filter 3/2024
7. Installing an electro WC 5/2024
8. Installing an automatic drain system from the shower 7/2024
Electrical system:
1. Starter batteries 2/200 Ah 10/2023
2. On-board batteries 24V 2/180 Ah 10/2023
3. Battery network 12v 1/180 Ah
4. Raymarine i70s instrument wind/speed/depth 5/2024
5. Installation of additional and replacement with diode lamps 7/2024
6. 360 video surveillance installed 7/2024
7. WiFi router 7/2024
8. Robertson Ap300x hydraulic autopilot works perfectly.
- The engine compartment has an entrance through the floor in the wheelhouse cabin and allows you to access any point of the engine without difficulty. The engine has an additional noise-proof housing that allows you to use the space of the engine compartment for storing canisters with fuel or other large loads. The Ford Lehman 120 engine is a deformed marine motor famous for its unpretentiousness and enormous resources. Engine bay work:
1. Removing old and making new stainless steel fuel tank 2/2024
2. Removing and cleaning stainless steel reserve fuel tank 6/2024
3. Replacing impeller 10/2023
4. Replacing engine cooling pump 6/2024
5. Changing oil and filters 6/2024
6. Replacing all fuel filters
7. Installing electric pump and filter for pumping fuel. 6/2024
8. Cleaning fuel system 5/2024
9. Adjusting and servicing high pressure fuel pump 6/2024
Additionally, there is a huge amount of materials, tools and spare parts. A full set of rescue equipment is available.
This boat is at sea and ready to go to sea.
Designed by Sitala, built by Sitala
Nauticat 44 — Classic and Reliable
A legendary yacht with a stable hull and exceptional handling.
• Epoxy hull, underwater thickness 5+ cm
• Full hull refit and gelcoat repaint — 10/2023
• Teak deck restored — 5/2024
• New seacocks, valves, hatch glass — all serviced
• Powerful bow thruster (5.5 kW), serviced — 5/2024
• Staysail schooner rig, all sails in excellent condition (serviced 6/2024)
• 2 cabins, 2 toilets, shower, hot water, fully renovated saloon (2024)
• Ford Lehman 120 engine — simple, reliable, fully serviced (2023–2024)
• Cruising speed: 8 knots at 1400 rpm, consumption: 5.5 l/h
• Autopilot, WiFi, 360° cameras, new electric pump and filters
• New batteries (10/2023), Raymarine equipment (5/2024)
• Large set of spare parts and equipment included
The boat is at sea and ready to sail. Located in Montenegro.
Engine & Drive:
• Ford Lehman 120 HP diesel engine
• Side-Power 5.3 kW bow thruster
Sails & Rigging:
• Mainsail, genoa, 2 working jibs, trysail, gennaker
• Telescopic bowsprit
• Sail covers: mainsail cover, lazy bag, 4 jib covers
• Spare blocks, shackles, and various rigging hardware
Navigation & Electronics:
• Raymarine and Simrad navigation
• Furuno radar and Navtex
• Autopilot, VHF, wind/depth/speed instruments
Energy & Power:
• Flexible solar panels with controller
• 5,000W inverter
• 4 service batteries (180 Ah each, total 720 Ah)
Deck & Mooring:
• 3 anchors with 100 m of 10 mm chain and anchor bridle
• 8 fenders with covers + 3 ball fenders
• 2 mooring lines (22 mm) with shock absorbers
• 2 mooring lines (10 m, 26 mm)
• 2 rod holders
• Protective deck covers
Safety:
• Life raft, life jackets
Tender:
• Neptune dinghy (2.4 m) + Honda 2.3 HP outboard
Interior & Comfort:
• 2 toilets (1 electric)
• Water tanks: 750 L total
• Diesel tanks: 750 L / 500 L / 450 L
• Kitchen: gas cooker with oven, electric cooktop, fridge
• Gas water heater
• LPG bottles: 1×10 L + 4×3 L
Entertainment:
• Boss marine radio/CD player
Other:
• Many additional spare parts, tools, and consumables included (not listed in full).
